Among the amazing stone mansions and club halls, there is a part that can be eye-catching and admirable, but also can be naturally integrated into the mansion, as if it was born to be a part of the mansion. What is it? ? It is the pillar supporting Haozai, the marble stone pillar. Marble column actual installation renderings Nowadays, there are endless processing technologies for stone columns, including large-area mosaic and cylindrical balls, with rich colors and different shapes. These techniques have greatly enriched the artistic and aesthetic expressiveness of the marble columns, and behind these complex techniques, there is the problem of glue filling.
Today, I will introduce to you the strategy of glue replenishment in the production process of marble cylinders. In the production process of marble columns, glue filling is a highly technical technology, which is very important to the quality of the product. The method steps can be divided into several items: The first step is to remove the mortar or other sundries in the cracks of the original marble, and the depth is 3-5mm. If it is granite, the width of the gap should be increased to about 10mm. The seams are cleaned.
In the second step, smash the marble that is close to the color and pattern of the crack with a small hammer. If it is granite, its particle size should be similar to that of granite. If it is monochromatic stone, it can be smashed into powder. The third step is to take an appropriate amount of transparent marble glue and crushed marble particles or powder and mix well, add an appropriate amount of drier, and then mix well, and apply the stirred mixture evenly on the cracks, and after coating the cracks, the cracks will be larger than the marble surface. It is advisable to be slightly higher than 0.5mm, and it will dry later.
The fourth step is to install No. 100 resin plastic sand sheet on the corner polishing machine, grind the dry cracks slightly, then install No. 220 resin film for fine grinding, and then polish the wall or ground with No. 360 water sandpaper Clean up water stains and stains, then use an angle grinder to install a cloth wheel to polish and polish with wax. After the luster appears, continue to polish until it is close to the luster of the original marble. Then dip a small amount of polishing wax with steel wool and polish by hand. Until the luster is completely the same as that of the original marble, at this time, the cracks cannot be seen. The fifth step, if there is a pattern in the monochromatic stone, the pattern is just at the crack. In addition to mixing the powder with glue, you should also use toner to make the color consistent with the pattern and embed it in the crack. Excellence in craftsmanship, just the right glue, can present the natural and artistic sense in our eyes, and the indispensable marble stone pillars in the hall of the mansion.
wood look porcelain floor tiles